ST-LINK/V2

File:ST-LINK-V2 in-circuit debugger-programmer for STM8 and STM32 User manual.pdf

• The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.

• In addition to provide the same functionalities as the ST-LINK/V2, the ST-LINK/V2-ISOL features digital isolation between the PC and the target application board. It also withstands voltages of up to 1000 Vrms.

STM8 applications use the USB full-speed interface to communicate with the ST Visual Develop (STVD) or ST Visual Program (STVP) software.

STM32 applications use the USB full-speed interface to communicate with Atollic®, IAR™, Keil®or TASKING integrated development environments.

Key Features

   *5 V power supplied by a USB connector
   *USB 2.0 full-speed-compatible interface
   *USB standard A to Mini- B cable

SWIM specific features

1. 1.65 V to 5.5 V application voltage supported on SWIM interface
2. SWIM low-speed and high-speed modes supported
3. SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
4. SWIM cable for connection to the application via an ERNI standard vertical connector (ref: 284697 or 214017) or horizontal connector (ref: 214012)
5. SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector

JTAG/serial wire debugging (SWD) specific features:

1. 1.65 V to 3.6 V application voltage supported on the JTAG/SWD interface and 5 V tolerant inputs
2. JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector JTAG supported
3. SWD and serial wire viewer (SWV) communication supported

• Direct firmware update feature supported (DFU)
• Status LED which blinks during communication with the PC
• Operating temperature 0 to 50 °C
• 1000 Vrmshigh isolation voltage (ST-LINK/V2-ISOL only)